Red Led Behavior And Projector Errors - Ask Proxima M1 User Manual

Red LED Behavior and Projector Errors

If the projector is not functioning properly and the red LED is blinking, con-
sult Table 2 to determine a possible cause. There are two second pauses
between the blinking cycles. Visit our website for more details on the red
LED error codes. See the inside back cover for contact details.
Red LED Behavior
One (1) blink
Two (2) blinks
Three (3) blinks
Four (4) blinks
Five (5) blinks
Solid red
Table 2:
Explanation
The lamp won't strike after five (5)
attempts. Check the lamp and lamp door
installations for loose connections.
The lamp counter hours have exceeded
lamp life hours. Replace the lamp and
reset the lamp hours counter.
The projector has shut down the lamp.
Turn off the projector and wait one
minute, then turn the projector on again.
Replace the lamp. Contact Technical Sup-
port for repair if replacing the lamp does
not solve the problem.
The fan has failed. Contact Technical Sup-
port for repair.
The projector is overheating. Check for a
blocked air vent. Contact Technical Sup-
port for repair if clearing the air vents
does not solve the problem.
Unidentifiable error: contact Technical
Support
Projected image size
Range of distance to the screen for a given screen size
Diagonal
Screen Size Image Width
(inches/m) (inches/m)
40/1 32/0.8
50/1.3 40/1
60/1.5 48/1.2
100/2.5 80/2
NOTE: Visit our website for an interactive image size calculator.
38
Table 3:
Distance to screen
Maximum Minimum
distance Distance
(feet/m) (feet/m)
5.6/1.7 4.8/1.5
6.9/2.1 6/1.8
8.2/2.5 7.2/2.2
13.8/4.2 12.1/3.7