Table of Contents
Advertisement
USER GUIDE
correctly, see WIDTH, POSITION and TUNE below. RESET is
automatically activated when a new source is connected.
3. CONTRAST and BRIGHTNESS may be adjusted according to your
personal taste, the image and the viewing conditions. The controls are
directly accessible on the projector keyboard.
4. WIDTH. The frequency controls the width of the image. A wrong
frequency setting can be seen as equally spaced, vertical stripes or
irregularities in the pattern displayed. Press the MENU key, ADVANCED,
PICTURE, WIDTH and press SELECT. Adjust the value up or down
using the trackball or keyboard cursor controls, observing that the
amount of vertical stripes reduces, until the distortion is gone. You may
still have an unstable image, please see the next section.
5. POSITION the image correctly by accessing ADVANCED, PICTURE,
POSITION, then press SELECT and adjust position with the trackball or
keyboard cursor controls
6. TUNE the image for a stable projection. In the menu, select
ADVANCED, PICTURE, TUNE and press SELECT. Adjust stability using
the trackball.
Set-up should be done once with the source(s) you are using most
frequently. Allow some minutes for the unit to warm up before adjusting the
settings. Most settings will be memorized individually for each source for
future use.
XGA LCD PROJECTOR
17
Advertisement
Table of Contents
