Netvanta 3000 Series Front Panel Leds; Table 1. Netvanta 3000 Series Front Panel Leds - ADTRAN NetVanta 3458-PoE Hardware Installation Manual

Physical Descriptions

NetVanta 3000 Series Front Panel LEDs

Table 1 describes the front panel LEDs.
LED
STATUS (STAT) Green (flashing)
Green (solid)
Red (solid)
WAN Off
Green (solid)
Green (flashing)
Red (solid)
Amber (solid)
DBU Off
Green (solid)
Green (flashing)
Red (solid)
Amber (solid)
NET TD/RD (not Off
present on all units)
Green (flashing)
LAN TD/RD (not Off
present on all units)
Green (flashing)
LNK (not present Green (solid)
on all units)
Amber (solid)
POE (not present Off
on all units)
Green (solid)
Red (solid)
ETH1/ETH2 (not Off
present on all units)
Green (solid)
Amber (flashing)
INET Off
(not present on all
units)
Green (solid)
Green (flashing)
SWITCH Off
(not present on all
Green (solid)
units)
Amber (flashing)
VPN Off
(not present on all
On
units)
52

Table 1. NetVanta 3000 Series Front Panel LEDs

Color
The unit is powering up. On power up the STAT LED flashes rapidly
for five seconds, during which time the user can escape to boot mode
from the console port. (For the 3120 and 3130, you must press the
factory default switch on the back of the unit while the STAT LED is
flashing green to escape to boot mode. Refer to
Switch on page 23
The power is on and self-test passed.
The power is on, but the self-test failed or the boot mode (if
applicable) code could not be booted.
No NIM is installed, or interface is administratively down.
The link is up and everything is operational.
The port has activity (3430/3448 only).
An alarm condition is occurring on the WAN interface, or there is a
self-test failure.
The unit is in test.
No DIM is installed.
The DIM is ready. For the ISDN BRI DIM, green solid indicates that
the negotiation with the switch is complete.
The unit is in dial backup.
An alarm condition is occurring on the DBU interface, or there is a
self-test failure.
The unit is in test.
There is no activity on the WAN or DBU port.
There is activity on the WAN or DBU port.
There is no activity on the Ethernet port.
There is activity on the Ethernet port.
The 10Base-T Ethernet link is up.
The 100Base-T Ethernet link is up.
PoE card not installed, or no attached devices are being powered.
PoE card is actively powering an attached device.
PoE card has detected a fault condition on an attached device.
The port is administratively disabled or does not have link.
The port is enabled and the link is up.
The port has activity (transmit or receive).
PPP or PPPoE is not connected, IP has no IP address via DHCP, or
IP is static.
PPP or PPPoE is connected or IP has an address via DHCP.
WAN interface is attempting to obtain an IP address via DHCP.
The port is administratively disabled or does not have link.
The port is enabled and the link is up.
The port has activity (transmit or receive).
No encrypted traffic.
Encrypted traffic present.
Copyright © 2010 ADTRAN, Inc.
NetVanta 3000 Series Hardware Installation Guide
Indication
for more information.)
Factory Default
61200860L1-34AA