Scsi Bus Interface Definitions - Siemens D981 Technical Manual

SCSI Bus Interface Definitions

SCSI Bus Interface Definitions
Host Adapter SCSI ID
All SCSI devices on one SCSI bus, including the Ultra-Wide SCSI controller, must
be set to separate SCSI IDs.
0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14, 15
The ultra-wide SCSI controller is set to the displayed SCSI address
(default entry: 7).
SCSI Parity Checking
The ultra-wide SCSI controller uses parity bits on the SCSI bus to verify the data
from your SCSI devices. Parity checking may not be supported on older SCSI
devices. You must disable the option in this case.
Parity checking is enabled (default setting).
Enabled
Parity checking is disabled.
Disabled
If parity checking is disabled, this applies to all SCSI devices on the SCSI
i
bus.
Host Adapter SCSI Termination
If the ultra-wide SCSI controller is the last device on the SCSI cable, its
termination must be enabled. If the ultra-wide SCSI controller is not the last device
on the SCSI cable, its terminator must be disabled.
LowON/HighON
The termination is enabled (default entry).
LowOFF/HighOFF
The termination is disabled.
LowON/HighON
Not supported.
22 - English
SCSI Setup
A26361-D981-Z120-9-7419