3Com SERVER LOAD BALANCER 3C16120 User Manual page 25

3 Hit <Return>. At the login: prompt, enter admin.
The Server Load Balancer provides two levels of access, admin and
monitor. The password field contains blank default login passwords. The
two levels of access are:
admin — the user can access and change all manageable
I
parameters
monitor — the user can view all manageable parameters, but
I
cannot change any parameters
4 At the password: prompt, hit <Return>. The password field contains
a blank default login password. The Welcome to the SLB Setup CLI
appears.
CAUTION: The Server Load Balancer does not provide a way to recover a
lost password. If you choose to assign a new password, it is suggested
you keep note of it in a safe place. If you forget your password, you will
be locked out of the unit. If you change the password during the CLI
Server Load Balancer setup, this is the password you should use, and not
the blank default login password. For Technical Support, see Appendix C.
Welcome to the SLB Setup
Follow the on-screen instructions to complete the setup
process.
You may run setup later by typing "setup" at the SEC> prompt.
Setup will take you through the following steps:
SEC>
1. Set unit ip address
2. Set default route
3. Set clock
4. Set login password
You may use <CR> to skip a step.
Enter unit ip in this format: nnn.nnn.nnn.nnn/pp
where: nnn.nnn.nnn.nnn is IP address
pp is address prefix
Assigning an IP Address 25