Operation; Pressure Relief Procedure; Application Data - Graco 238377 Instructions Manual

Single acting and double acting paint spray guns for roadlazer roadpak line striping system
Hide thumbs Also See for 238377:
Table of Contents

Advertisement

Operation

Adjustments
Set the actuating air to at least 75 psi (5.2 bar) and start
the pump. Set the pump speed and pressure to obtain the
desired flow rate. Always use the lowest pump speed nec-
essary to achieve desired results.

Pressure Relief Procedure

FLUID INJECTION HAZARD
To reduce the risk of serious bodily injury, including
fluid injection, splashing in the eyes or on the skin, or
injury from moving parts, always follow this procedure
whenever you shut off the pump, when checking or
servicing any part of the dispensing system, when
installing, cleaning, or changing part of the valve and
whenever you stop dispensing.

Application Data

APPLICATION
RECOMMENDATIONS*
Paint Tip Size
For a 4 inch (101 mm)
wide line
LL5333
For a 6 inch (152 mm)
wide line
LL5439
For a 12 inch (304 mm)
wide line
Operating Pressure
psi (bar)
1500-2000
Paint System
* Coverage may vary depending on paint used.
308613E
3
4
5
(5)
(6)
(8)
433
433
439
LL5333
539
539
543
LL5439
LL5443
643
649
1500-2000
1500-2000
(102)
(102)
(102)
1. Shut off the power to the pump.
2. Close the bleed-type master air valve (required with
air-powered pumps).
3. Actuate the dispensing valve to relieve pressure.
4. Open the pump drain valve (required in your system) to
help relieve fluid pressure in the displacement pump.
Actuating the dispensing valve to relieve pressure may
not be sufficient. Have a container ready to catch the
drainage.
5. Leave the drain valve(s) open until you are ready to
dispense again.
If you suspect that the dispensing valve or hose is com-
pletely clogged, or that pressure has not been fully relieved
after following the steps above, very slowly loosen the
hose end coupling and relieve pressure gradually, then
completely loosen. Then clear the valve or hose.
TRAVEL SPEED IN MILES PER HOUR (KPH)
Based on 15 mils (.381 mm) wet paint
6
7
(10)
(11)
(12)
439
443
443
LL5343
LL5343
549
559
561
1500-2000
1500-2000
1500-2000
(102)
(102)
(102)
8
9
10
(14)
(16)
445
449
565
1500-2000
1500-2000
(102)
(102)
Operation
11
12
(18)
(19)
453
457
1500-2000
1500-2000
(102)
(102)
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

24g980

Table of Contents