Table of Contents
Advertisement
6
OTHER FUNCTIONS
Selecting on the plotter display:
1.
Push [◄] or [►] to select an AIS target or waypoint.
• A target box is displayed around the selected target.
(p. 13)
2.
Push [ENT] to display the Menu window.
• The Menu window is displayed.
3.
Select "Navigate to," and then push [ENT].
• "Start navigation. Are you sure?" is displayed.
4.
Select "OK," and then push [ENT] to start navigation.
• The target's current position is set as a waypoint.
• The AIS and Highway screen is displayed, and the
transponder starts to navigate
NOTE:
• An alarm sounds, and a popup screen is displayed
when the vessel arrives at or near the destination. To
stop the alarm and navigation, push any key.
• An alarm sounds, and a popup screen is displayed
when the vessel goes off course.
L When the vessel comes back on course, the alarm
automatically stops.
• If the transponder is turned OFF during navigation, the
transponder continues navigation.
D Stopping navigation
1.
Push [NAV] to stop navigation.
• "Stop navigation. Are you sure?" is displayed.
L The transponder can also stop navigation by pushing
[CLR] when no target is selected.
2.
Select "OK," and then push [ENT].
• The transponder stops to navigate.
D Resetting navigation
The transponder resets the start position, and restarts
navigation from your current position.
L The function works only when the transponder is receiving
valid GPS signals.
L The function cannot work while in the MOB mode, or when
the transponder does not navigate.
1.
Open the "Navigation settings" screen.
[MENU] > Navigation settings
2.
Push "Reset navigation" to reset the start position.
• The popup screen is displayed.
3.
Select "OK," and then push [ENT].
• The transponder resets the start position, and restarts
navigation from your current position.
29
.
Hide quick links:
Advertisement
Table of Contents
