Recommendation; Installation Note; About Ce And Doc; Disposal - Icom MA-510TR Instruction Manual

Class b ais transponder
Hide thumbs Also See for MA-510TR:
Table of Contents

Advertisement

■ Recommendation

CLEAN THE TRANSPONDER THOROUGHLY WITH FRESH WATER after exposure to
saltwater, and dry it before operating. Otherwise, the transponder's keys, switches and
controllers may become unusable, due to salt crystallization.
L The DC power cable does not meet IPX7.
NOTE: If the transponder's waterproof protection appears defective, carefully clean it
with a soft, wet (fresh water) cloth, then dry it before operating.
The transponder may lose its waterproof protection if the case or connector is cracked
or broken, or the transponder has been dropped.
Contact your Icom distributor or your dealer for advice.

■ Installation note

Installation:
The installation of this equipment should be made in such a manner as to respect the EC
recommended electromagnetic field exposure limits. (1999/519/EC)
The maximum RF power available from this device is 2 watts. The antenna should be
installed as high as possible for maximum efficiency and the installation height should be
at least 0.4 meters above any accessible position. In the case where an antenna cannot
be installed at a reasonable height, then the transmitter should neither be continuously
operated for long periods if any person is within a distance of 0.4 meters of the antenna,
nor operated at all if any person is touching the antenna.
It is recommended that antenna of a maximum gain of 3 dB is used. If higher gain
antenna is required then please contact your Icom distributor for revised installation
recommendations.
Operation:
The exposure to RF electromagnetic field is only applicable when this device is
transmitting. This exposure is naturally reduced due to the nature of alternating periods of
receiving and transmitting. Keep your transmissions to the minimum necessary.

■ About CE and DOC

Hereby, Icom Inc. declares
that the versions of
MA-510TR which have the
"CE" symbol on the product,
comply with the essential requirements of
the Radio Equipment Directive, 2014/53/
EU, and the restriction of the use of certain
hazardous substances in electrical and
electronic equipment Directive, 2011/65/
EU. The full text of the EU declaration of
conformity is available at the following
internet address:
http://www.icom.co.jp/world/support

■ Disposal

The crossed-out wheeled-
bin symbol on your product,
literature, or packaging
reminds you that in the
European Union, all electrical
and electronic products,
batteries, and accumulators
(rechargeable batteries) must be taken
to designated collection locations at the
end of their working life. Do not dispose
of these products as unsorted municipal
waste. Dispose of them according to the
laws in your area.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
ii

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents