Table of Contents
Advertisement
Available languages
Available languages
Key Description
A
Air hose
B
In-line Filter
C
Tee Fitting
To begin using the tool:
1. As a standard practice, drain water from the air
compressor tank and air lines prior to use each day
(reference your compressor operators manual for
detailed instructions).
2. Turn on the air compressor and allow it to build up
pressure.
3. Adjust the air compressor's regulator or the supply
line regulator to 90 PSI.
4. Remove the head of the grease gun from the
container tube.
5. Connect the air tool to the air hose quick coupler and
press the trigger to actuate the air piston in the head
of the grease gun. NOTE: If the piston does not move
back and forth, see the "Troubleshooting Guide".
6. Grease gun is ready to load grease.
Always disconnect the grease gun from the air supply before loading
grease.
Loading grease:
This air grease gun is designed to load in three ways.
• Using a standard 14oz. grease cartridge.
• Loading the container tube with a filler pump.
• Loading the container tube by bulk filling.
Cartridge loading (Figure C):
a. Remove the head of the grease gun from the container tube.
b. Pull the plunger handle on the container tube completely out.
b1. Remove the seal or tab end from the end of the grease cartridge.
b2. Take index finger and grab approximately 2 tablespoons of grease and coat the first
3"- 4" of the end of the container tube (figure D).
b3. Press the handle release and let plunger go all the way to the end.
Pull the plunger handle approximately 4-5 times so the rubber
plunger gets coated with grease. This will make the plunger go into
the grease cartridge easier.
c. Insert the grease cartridge (open end first) all the way into the container
tube.
d. Reassemble the head of the grease gun to the container tube.
e. Press the handle release to release the plunger handle.
f. Push the plunger handle all the way in while pressing the handle release.
g. Press the air vent valve to release any excess air trapped inside.
TYPICAL INSTALLATION
Key Description
D
In-line Oiler
E
Air Hose
F
Whip Hose w/Swivel
OPERATING INSTRUCTIONS
Key Description
G
Quick Coupler
H
Male Plug
I
Air Tool
B
1
Grease gun head
2
Air inlet port
3
Female plug
4
Container tube
5
Handle release
4 - ENG
Key Description
J
Female Plug
K
Spray Gun
1
9
8
7
6
Plunger handle
7
Trigger
8
Filler plug
9
Air vent valve
D
A
2
3
4
5
6
C
Hide quick links:
Advertisement
Table of Contents
