3Com IntelliJack NJ1000 Quick Start Manual page 11

5. Set Up the Network Cabling
The network cabling (from the wiring closet to the wall opening) may already be
installed. If it is not, install the cabling following these general guidelines.
CAUTION: 3Com recommends that a professional cable installer perform these
procedures. Be sure to adhere to local safety and regulatory codes during the cable
installation.
1 Connect one end of an Ethernet cable to the network. Usually, this
connection is made in a network wiring closet, via the patch panel.
2 Terminate the other end of the cable at the location where the
NJ1000 is being installed (using either a female or male RJ-45
connector). Refer to the connector manufacturer's instructions for
terminating the cable. Be sure to test the connector and verify that it
is working.
6. Connect the NJ1000 to the Network
The method for connecting the NJ1000 to the network is determined by how the
network cable is terminated, as described in step 5.
If the end of the cable is terminated with a female RJ-45 connector, use one of
■
the RJ-45 coupler cables included in the NJ1000 package to connect the NJ1000
to the network cable.
11