ViewSonic X100-4K User Manual page 74

If you are in a Manual Static IP environment:
1. Take a RJ45 cable and connect one end to the RJ45 Control port of the projector,
and the other end to your network.
2. Go to: Setting > Network Settings > Wired LAN Control.
3. Highlight LAN Settings and select Manual IP.
4. Contact your ITS administrator for information on the Projector IP Address,
Subnet Mask, Default Gateway, and DNS Server.
5. Using the directional buttons, select the item you want to modify, and press Left/
Right to enter the value.
6. To save, select Apply and press Enter.
NOTE: If the RJ45 cables are not properly connected, the Projector IP Address,
Subnet Mask, Default Gateway, and DNS Server will display 0.0.0.0.
Ensure the cables are properly connected and try the above steps again.
74