ViewSonic X100-4K User Manual page 73

Controlling the Projector through a LAN Environment
The projector supports Crestron® software. With the correct settings in the LAN
Control Settings menu, you can manage the projector from a computer using a web
browser when the computer and projector are properly connected to the same
local area network.
Configuring the LAN Control Settings
If you are in an Automatic IP environment:
1. Take a RJ45 cable and connect one end to the RJ45 Control port of the projector,
and the other end to your network.
2. Go to: Setting > Network Settings > Wired LAN Control.
3. Select Configure IP and ensure it is set to Automatic.
4. Wait for 15-20 seconds, then re-enter LAN Settings. Now, the projector's
IP Address, Subnet Mask, Default Gateway, and DNS Server settings will be
displayed.
5. Make note of the IP Address displayed in the Projector IP Address row.
NOTE:
• If the Projector IP Address still does not appear, contact your network
administrator.
• If the RJ45 cables are not properly connected, the Projector IP Address,
Subnet Mask, Default Gateway, and DNS Server will display 0.0.0.0. Ensure
the cables are properly connected and try the above steps again.
• If you need to connect to the projector in its Standby Mode, set Standby
LAN Control to On in the Network Settings menu.
VGA IN
YPbP r
RJ45
LAN
L A N CONTROL
73
HDM I
RS-23 2
RJ45