Steps
1. Align and place the keyboard on the keyboard support plate and secure it using the two (M2x2) screw.
2. Replace the keyboard assembly in to its slot in the computer.
3. Connect the keyboard FPC and keyboard backlight FPC to the touchpad module.
4. Replace the 26 (M1.6x1.7) screws that secure the keyboard assembly to the computer.
5. Adhere the LED board FFC, USH board FFC , touchpad FFC and, SmartCard reader FFC to the back of the keyboard.
Next steps
1. Install the
I/O
board.
2. Install the
system
board.
3. Install the
audio
board.
4. Install the
heatsink
assembly.
5. Install the battery.
6. Install the
WWAN
card.
7. Install the
solid-state
8. Install the
base
cover.
9. Install the
microSD
card.
10. Follow the procedure in
Palmrest assembly
Removing the palmrest assembly
Prerequisites
1. Follow the procedure in
2. Remove the
microSD
3. Remove the
SIM card
4. Remove the
base
cover.
5. Remove the
solid-state
drive.
after working inside your
before working inside your
card.
drive.
computer.
computer.
Removing and installing components
59