3Com 5500-EI Getting Started Manual page 66

66 C 3: S U
HAPTER ETTING
1 To start a Telnet session to the unit, from Microsoft Windows, click Start >
2 Press Enter to open a login prompt.
3 At the Username prompt, enter
4 Enter the system-view command and press Enter.
5 Enter interface vlan 1 and press Enter.
6 Enter the IP address and subnet mask for the switch as follows:
7 Enter the default gateway for the switch:
8 From the User View, enter the save command to save the configuration
M
P FOR ANAGEMENT
Using the Command Line Interface through Telnet
Run. In the Open field type Telnet xxx.xxx.xxx.xxx (where
xxx.xxx.xxx.xxx is the switch's IP address) and click OK.
If the login prompt does not begin immediately, press Return a few times
until it starts.
Return. At the password prompt press Return again. If you have logged
on correctly, <5500G-EI> or <5500-xx> is displayed (where xx is either
SI or EI) as shown in the example in Figure 29.
Figure 29 User View Login using Telnet
ip address xxx.xxx.xxx.xxx mmm.mmm.mmm.mmm
(where xxx.xxx.xxx.xxx is the IP address and mmm.mmm.mmm.mmm is
the subnet mask of the switch)
ip route-static 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx
(where xxx.xxx.xxx.xxx is the IP address of the default gateway)
to your switch because the configuration is not saved automatically when
you power down the switch.
as your user name and press
admin