3Com 5500-EI Getting Started Manual page 105

Europe only: The supply plug must comply with CEE 7/7 ("SCHUKO").
■
The mains cord must be <HAR> or <BASEC> marked and
■
be of type H03VVF3GO.75 (minimum).
Denmark The supply plug must comply with section 107-2-D1,
■
standard DK2-1a or DK2-5a.
Switzerland The supply plug must comply with SEV/ASE 1011.
■
WARNING: The appliance coupler (the connector to the unit and not the
wall plug) must have a configuration for mating with an EN60320/IEC320
appliance inlet.
WARNING: The socket outlet must be near to the unit and easily
accessible.
WARNING: This unit operates under SELV (Safety Extra Low Voltage)
conditions according to IEC 60950. The conditions are only maintained if
the equipment to which it is connected also operates under SELV
conditions.
WARNING: France and Peru only:
This unit cannot be powered from IT
type, this unit must be powered by 230V (2P+T) via an isolation
transformer ratio 1:1, with the secondary connection point labelled
Neutral, connected directly to earth (ground).
† Impédance à la terre.
WARNING: U.K. only:
If connecting a modem to the console port of the Switch 5500, only use a
modem which is suitable for connection to the telecommunications
system.
WARNING: RJ-45 Ports. These are shielded RJ-45 data sockets. They cannot
be used as standard traditional telephone sockets, or to connect the unit to a
traditional PBX or public telephone network. Only connect RJ-45 data
connectors, network telephony systems, or network telephones to these
sockets.
Either shielded or unshielded data cables with shielded or unshielded
jacks can be connected to these data sockets.
WARNING: Fiber Optic ports – Optical Safety
Important Safety Information
†
supplies. If your supplies are of IT
105