Sony VPL-FHZ700L Service Manual page 53

Procedure
1. Blow off the dust and dirt adhered to the surface of the in-polarizer (G) assembly and in-polarizer (B)
assembly.
2. Perform the cleaning of the in-polarizer (R) assembly.
The in-polarizer (R) assembly uses the organic polarizing fi lm. Therefore, you can wipe off the dust
and dirt on it. Clean the in-polarizer (R) assembly with the tissue paper dampened with drinking
water. After that, fi nish wiping with clean tissue paper and drinking water so as not to leave any
fi ngerprints and smudges.
In-polarizer (B) assembly
Glass
surface
Blow air.
3. Attach the in-polarizer (R)/(G)/(B) assemblies.
n
The in-polarizer (R)/(G)/(B) assemblies do not require adjustment.
Attach the in-polarizer (R)/(G)/(B) assemblies so that each screw is located in the center of the elon-
gate hole.
in-polarizer (G) assembly
Optical unit (F) assembly (top view)
VPL-FHZ700L
Glass
surface
Blow air.
In-polarizer (G) assembly
The screw is located in the
center of the elongate hole.
Glass
surface
Clean by wiping.
In-polarizer (R) assembly
1-45 (E)