Saving To Memory; Switching Memories - Roland BOSS OD-200 Owner's Manual

Saving and Switching Memories

Saving to Memory

Here's how to save effect settings that you edited.
1.
Long-press the [MEMORY] button.
The display indicates "Wrt. "
2.
Turn the [PARAM] knob to select the save-
destination (MAN, 1–127).
You can also select the save-destination by pressing
the [MEMORY] button.
If you decide to cancel, press the [PARAM] button.
3.
Long-press the [MEMORY] button to confirm
the save-destination.
The memory is saved.
* If you save to MAN, the settings of the panel are applied as the
values for MODE, DRIVE, LEVEL, LOW, MIDDLE, and HIGH.
8

Switching Memories

Here's how to recall a saved memory.
1.
Press the [MEMORY] button to select a
memory.
Each time you press the button, you cycle through
the memories in the order of "MAN (manual) 0 1
0 2 0 3 04 ...1270 MAN... "
You can also switch memories by holding down the
[MEMORY] button and turning the [PARAM] knob.
* The MEMORY indicator is unlit if a memory 5–127 is selected.
MEMO
You can specify the memory switching range by editing
the ETF and ETT
(EXTENT FROM)
What is "MAN" (manual)?
This unit normally applies the effect according to the
settings that are saved in memory, but if you select
MAN (manual) the effect is applied according to the
positions of the panel knobs. Even in this case, the
booster and gate settings recall the settings that are
written to MAN (this can be changed).
settings (p. 11).
(EXTENT TO)