Table of Contents
Advertisement
Digital output terminal
Remove the protection cap for use.
(Take care not to lose the cap.)
Optical fiber cable
OPTICAL
Remove cap
DIGITAL
OUTPUT
Always execute
the connection be-
tween DP-MH5 and
DM-H5 at this posi-
tion.
Speaker (left)
3 3
Speaker Section
Digital input terminal
Remove the protection
OPTICAL
OPTICAL
cap for use.
1
2
(Take care not to lose
the cap.)
Remove cap
Optical fiber cable
Speaker cord
Connect correctly + to + and - to -.
1
2
Twist
3
4
Note on connection of optical-fiber cable
Insert the optical-fiber cable straight into the connector until
it clicks.
Be sure to attach the protection cap when the connector is
not used.
Never bend or bundle the optical-fiber cable.
All of the optical-fiber cables sold in audio stores cannot
always be used.
If the cable you purchased cannot be connected to this unit,
please consult your dealer or KENWOOD distributor.
Caution regarding placement (Front view)
To maintain proper ventilation, be sure to leave a space
around the unit (from the largest outer dimensions in-
cluding projections) equal to, or greater than, shown
below.
Top panel : 50 cm, Rear panel : 10 cm, Left and right panel
: 10 cm
Please install as shown, as otherwise fire may be caused
by overheating.
Caution
Caution
1. Be sure to insert all connection cords securely. If their
connections are imperfect, the sound may not produced or
noise may interfere.
2. Before plugging or unplugging a connection cord, be sure to
unplug the power cord from the wall AC outlet, if connection
cords are plugged or unplugged with the power cord left
plugged in, malfunction or damage may result.
Notes
Notes
1.When arranging the system units in a vertical, stacked
configuration, observe the stacking order indicated in the
system connection diagram.
2. In case an associated system component is connected, also
read the instruction manual of the component.
3. Align the front panels of the unit flush.
4. Never short-circuit the + and – speaker cords.
5. If the left and right speaker connections or the + and – polarity
are inverted, the sound will be unnatural with unclear position-
ing of musical instruments, etc. Be sure to connect them
without mistake.
7
Before applying power
System connection
XD-9580MD (En)
Advertisement
Table of Contents
