Operation - Breville Precision Brewer BDC455 Instruction Book

WATER HARDNESS SETTING &
FLUSHING
1. Ensure that the empty coffee basket and
empty carafe (with assembled lid) are
inserted into the machine.
2. Fill the water tank with fresh cold water to
the MAX mark on the water tank. Plug into
power outlet.
3. When first turned on, the machine will
show 'SEt HArdnESS' on LCD, asking you
water hardness level. Press SELECT dial
once. Dip the water hardness test strip into
the filled water tank for 1 second, remove
and wait for 1 minute to reveal the result.
Rotate SELECT dial and press the dial to
select the level according to the number
of dots shown on the strip. To reset water
hardness, please refer to FACTORY RESET
(page 18).
4. The machine will show 'FLUSH Unit'
on LCD. Press SELECT dial once. The
machine will dispense all the water from
the tank, through the system & into the
empty carafe. After flushing, empty the
basket and carafe.
10

Operation

BREWING A CARAFE
Ensure the brew basket is clean and the drip
stop seal in the bottom of the basket is clean
and free of coffee particles.
1. Select the correct basket & filter for the
amount of coffee you're making. When
brewing between 2 and 8 cups, we
recommend you use the Cone shaped filter
basket insert with paper filter (Cone paper
filter is not included). When brewing more
than 8 cups, use mesh basket filter or flat
bottom brew basket with large paper filter.
OR
✔
2 - 8
CUPS
CAUTION
Filling the basket without a mesh basket filter
or filter paper may cause the basket to overflow
during the brewing cycle.
2. The LCD will display the basket setting -
"Basket" or "Cone". To change the basket
type, rotate the SELECT dial to Settings &
press the dial. Rotate the SELECT dial to the
basket type, press the SELECT dial to set.
3. Fill the water tank with fresh cold water up
to the MAX marking on the water tank.
OR
✔
8+
CUPS