Powering Up The Projector And Adjusting The Image - Toshiba TDP-S1-US User Manual

S e t t i n g
NOTE: Always use the power cord
that shipped with the projector.
NOTE: With some computers,
the order in which you power up
the equipment is very important.
Most computers should be turned
on last, after all other peripherals
have been turned on. Refer to your
computer's documentation to
determine the correct order.
10
u p t h e

Powering up the Projector and Adjusting the Image

1 Remove the lens cap.
2 Plug the power cord into the side of the projector, then plug it
into your electrical outlet. A surge-protected power strip is
recommended.
3 Turn on the projector by pressing the "I" side of the power
switch (see Figure 2 on page 3).
The startup screen displays and the Power LED on top of
•
the projector lights up (Figure 11 on page 15).
4 If you connected a video player, turn it on.
The video image should display on the projection screen. If
•
a computer source is active, press the
keypad (page 15) to display your video image. You can
select a default source to determine which source the pro-
jector examines first during power-up for active video; see
"Default Source" on page 24.
Use the
•
5 Turn on your computer.
The computer image should display on the projection
•
screen. (If a video source is active, press the
on the keypad (page 15) to display your computer's image.)
Make sure your computer's external video port is activated;
see "Portable and Computer Activation Chart" on page 39
for details.
If necessary, make adjustments to the image from the pro-
•
jector's on-screen menus. To open the menus, press the
button on the keypad, then select the Display or
menu
Image sub-menu. For more information about the menus,
see page 17.
P r o j e c
buttons to adjust the volume.
volume
t o r
button on the
source
source
button