Disassembling The Cartridge - Brother TN-210 Series Remanufacturing Instructions

DISASSEMBLING THE CARTRIDGE

STEP 2.1
Screws
On the drive side end plate, remove the two screws as shown
in Figure 2.1.
STEP 2.3
Remove the drive side end plate (Figure 2.3).
STEP 2.5
Remove the flag gear spring and the flag gear (Figure 2.5).
Visit Static Control on the web @ www.scc-inc.com
®
Phillips
Screwdriver
FIGURE 2.1
Drive Side
End Plate
FIGURE 2.3
Flag Gear
Spring
Flag Gear
FIGURE 2.5
STEP 2.2
Use a small slotted screwdriver to release the locking tab on
the underside of the drive side end plate (Figure 2.2).
STEP 2.4
Remove Gear
Remove the cartridge drive gear (Figure 2.4) and check the
boss for alignment.
Note: See warning on page 5.
STEP 2.6
3
Remove the gears from the drive side of the cartridge in the order
shown. Idler drive gear (1), agitator drive gear (2), idler gear (3), and
the toner adder roller drive gear (4) (Figure 2.6).
Note: See warning on page 5.
SSS 1127
™
Locking Tab
Small Slotted
Screwdriver
FIGURE 2.2
FIGURE 2.4
1
2
4
FIGURE 2.6
1127 |
SSS
™
6