Toshiba D-R420KU Owner's Manual page 85

Playback (cont'd)
2
Audio Out
Choose the appropriate audio setting for your external device.
It will only affect a disc playback.
Use [K / L] to select a desired item, then press [ENTER].
Audio Out
A
Dynamic Range Control
B
PCM
C
Dolby Digital
DTS
D
A
Dynamic Range Control (Default : ON)
Set to "ON" to compress the range between soft and loud sounds.
Use [K / L] to select a setting, then press [ENTER].
Dynamic Range Control
ON
OFF
Your setting will be activated.
Note
• Dynamic range control function is available only on
the discs which are recorded in the Dolby Digital
format.
B
Settings for PCM (Default : 48kHz)
Use [K / L] to select a setting, then press [ENTER].
PCM
48kHz
96kHz
Your setting will be activated.
48kHz : If your amplifier/decoder is NOT compatible
with 96kHz PCM, select "48kHz". 96kHz sound
will be output in 48kHz.
96kHz : If your amplifier/decoder is compatible with
96kHz PCM, select "96kHz". 96kHz sound will
be output.
Note
When playing back disc with copyright protection
• Even if you select "96kHz", the sound will be down
sampled at 48kHz.
E7PCAUD_DR420KU_EN.indd 85 E7PCAUD_DR420KU_EN.indd 85
GENERAL SETTING
C
Settings for Dolby Digital (Default : Stream)
Use [K / L] to select a setting, then press [ENTER].
Your setting will be activated.
PCM
Stream : Outputs Dolby Digital signals.
D
Settings for DTS (Default : ON)
Select a setting using [K / L], then press [ENTER].
Your setting is activated.
ON
OFF
Dolby Digital
PCM
Stream
: Converts the Dolby Digital into PCM (2 channel).
When your amplifier/decoder is NOT
compatible with Dolby Digital, set to "PCM".
When your amplifier/decoder is compatible
with Dolby Digital, set to "Stream".
DTS
ON
OFF
: Outputs DTS signals.
If your amplifier / decoder is compatible with
DTS, set to "ON".
: No DTS signal is output.
If your amplifier / decoder is NOT compatible
with DTS, set to "OFF".
EN EN 85 85
2/6/2009 10:56:00 AM 2/6/2009 10:56:00 AM