Isassembling The Artridge - Brother TN-310BK Remanufacturing Instructions

D
isassembling The
1. Using a Phillips screwdriver, remove the screw on the contact side
end plate as shown in Figure 1.
Contact
Side
2. Using a slotted screwdriver pry under the contact side support
bearing as shown, to remove support bearing and spring (Figure 2).
Support
Bearing
3. Locate the locking tab under the contact side end plate and release
the tab using a small slotted screwdriver as shown in Figure 3a.
Remove the contact side end plate (Figure 3b).
C
arTriDge
End Plate
Screw
Phillips
Screwdriver
Figure 1
Slotted Screw
driver
Figure 2
Contact Side
End Plate
Locking Tab
Slotted
Screwdriver
Figure 3a
Contact Side
End Plate
Figure 3b
4. On the drive side end plate, remove the three screws as shown in
Figure 4.
Screws
5. Remove the drive side end plate as shown in Figure 5.
6. Remove the gears and spring in the order shown in Figure 6.
Agitator Gear
Idler Gear 1
Note: Keep the gears. They will be used again.
Figure 4
Figure 5
3 Flag Gear
4
Flag Gear
Spring
2
Figure 6
sss
™
1143 5
page