Ssembling The Rum Nit - Brother TN-310BK Remanufacturing Instructions

a
ssembling The
1. Rotate the drum unit so the replacement drums are facing down as
shown in Figures 49a and 49b.
Figure 49a
Figure 49b
2. Align the tabs on the bottom of the drum unit with the corresponding
holes in the end plates (Figures 50a and 50b).
Tabs
Holes
Figure 50a
Figure 50b
D
rum
Drum Unit
Drum Unit
Tabs
Holes
u
niT
3. Rotate the end plates up and secure each end plate with 5 screws
(Figures 51a, 51b and 51c).
Figure 51a
Phillips
Screwdriver
Screws
Drive Side
End Plate
Drive Side End Plate
Screws
Figure 51b
Contact Side End Plate
Phillips
Screwdriver
Figure 51c
sss 1143
™
page
17