Pride Mobility KOLJA ELITE Owner's Manual page 20

I N S P E C T I O N A N D M A I N T E N A N C E
 Suggestion
Ask for help from your scooter dealer to inspect or replace the fuse, since the tiller
shroud has to be removed first before you can replace the fuse.
■ Tires
 The condition of the tires depends on how you drive and use your scooter.
 Inspecting tire tread.
 Please check the tread groove regularly. Replace the tires when the tread groove is less
than 0.5 mm.
 Attention
1.When tread groove is below 0.5mm it can easily lead to vehicle slippage, making
braking distances longer. therefore, replace the tires as early as possible when they do
not have insufficient tread depth.
2.The tire pressure shall be kept at about 26 PSI (approx. 1.8KG/cm) for the best ride
and handling.
3.When conducting maintenance of your vehicle, please turn the power switch to OFF
and remove the charger cords.
■ 6.4 STORAGE
 Make sure the vehicle is stored under the following circumstances:
 Make sure the seat is set in the "Forward"position.
 Make sure the Power switch is turned to OFF.
 Suggestion
Please store the scooter in a location where it is away from the direct sunlight, rain,
or dew.
When storing for a long time, please charge the battery to full power and then
disconnect the battery terminal. For details inquire to your scooter dealer.
■ 6.5 MOVING ABOUT
 Turn the power switch "OFF" before moving.
 Lift the scooter by the chassis, and not by the bumpers. Lifting the scooters by the
bumper could cause damage or injury.
 For your safety, always ask for help if required. You will need 2 or 3 persons when
moving or lifting the vehicle.
18