Using The Remote Control; Preparing The Remote Control For Use; Installing The Remote Control Batteries; Using The Remote Control To Operate Your Other Devices - Toshiba 30HF66 Owner's Manual

Using the remote control

Preparing the remote control for use

In addition to operating the TV, the remote control can operate most
cable TV converters, satellite receivers, VCRs, and DVD players,
regardless of their brand. The remote control is pre-programmed to
operate most Toshiba satellite receivers, VCRs, and DVD players. To
control a non-Toshiba device (or a Toshiba device that the remote
control is not pre-programmed to operate), you must first program the
remote control. See "Programming the remote control to operate your
other devices" on the next page.

Installing the remote control batteries

To install the batteries:
1. Open the battery cover on the back of the remote control.
2. Install two "AAA" size batteries. Match the + and – signs on the
batteries to the signs on the battery compartment.
3. Close the battery cover on the remote control until the lock snaps.

Using the remote control to operate your other devices

To control a cable TV
converter/satellite
receiver:
Program the remote
control to recognize the
brand of your cable TV
converter/satellite receiver
(see "Programming the
remote control to operate
your other devices" on the
next page). The buttons
shown at right will control
the cable TV converter/
satellite receiver.
Press "CBL/SAT" first.
3W70721A_En_p15-22 15
Power
Input (TV)
Mute (TV)
Channel
Numbers
CH RTN
(Channel Return)
Channel M/? M/? M/? M/? M/?
CBL/SAT
Volume +/– (TV)
Pic Size (TV)
TV/VCR
Note:
The TV remote control may not operate your
VCR, DVD player, or cable TV converter.
Refer to the owner's manual supplied with
your other devices to see which features may
be available. Additionally, the remote control
for this TV may not support certain features
available on the original remote controls for
your other devices, in which case it is
suggested that you use the original remote
control for the applicable device.
Caution:
• Never throw batteries into a fire.
Note:
• Be sure to use "AAA" size batteries.
• Dispose of batteries in a designated
disposal area.
• Batteries should always be disposed of with
the environment in mind. Always dispose of
batteries in accordance with applicable
laws and regulations.
• If the remote control does not operate
correctly, or if the operating range becomes
reduced, replace batteries with new ones.
• Always remove the batteries from the
remote control if they are dead or if the
remote control is not to be used for an
extended period of time. This will prevent
battery acid from leaking into the battery
compartment.
To control a VCR:
Program the remote
control to recognize
the brand of your VCR
(see "Programming the
remote control to
(Channel Return)
operate your other
Channel M/?
devices" on the next
Volume +/– (TV)
page). The buttons
Pic Size (TV)
shown at right will then
control the VCR.
Press "VCR" first.
VCR controls
15
20/3/06, 9:32 AM
Input (TV)
Power
Channel
Numbers
CH RTN
VCR
M/? M/? M/? M/?