Adjusting The Self-Propel Drive - Toro 21750 Operator's Manual

Figure 26
Important:
Position the curved ends of the
blade to point toward the machine housing.
6. Use a torque wrench to tighten the blade bolt
to 82 N∙m (60 ft-lb).
Adjusting the Self-Propel
Drive
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive cable.
1. Loosen the cable-support nut
g231390
1. 25 to 38 mm (1 to 1-1/2
inches)
2. Self-propel-drive bar
3. Cable jacket
2. Hold the self-propel-drive bar 25 to 38 mm (1 to
1-1/2 inches) from the handle
3. Pull down the cable jacket (toward the machine)
until there is no slack in the cable
4. Tighten the nut on the cable support.
5. Release the self-propel-drive bar and ensure
that the cable is loose.
Note:
The cable must be loose with the
self-propel drive bar in the released position;
otherwise, the machine may creep when you
disengage the bar.
20
(Figure 27).
Figure 27
4. Cable-support nut
5. Cable support
(Figure 27).
(Figure
g009692
27).