Installation And Care - FWE RHRB-20 Operating Instructions Manual

FWE RETHERM DOCKING SYSTEM OVEN

INSTALLATION AND CARE

SERIAL AND MODEL NUMBER
These numbers are found on the nameplate (serial tag) affixed to
the lower back of the unit. Please record them in this booklet, in the
space provided on page 13. When ordering parts and/or service,
you will need to provide this information. The voltage and amperage
of the unit are also stamped on the serial tag.
UNPACKING
After uncrating your cabinet, remove all tape and padding which
held all doors, shelves, racks, cord, etc., in place during shipment.
ELECTRICAL REQUIREMENTS AND GROUNDING
FWE RHRB-20 models operate on 208/240 volt, 60 Hz, 3 ph, A.C.
(unless ordered otherwise). If you have any questions with regard
to adequate wiring or grounding in your building, a qualified
electrician should be contacted before using your cabinet.
The amperage of your cabinet is stamped on the name plate
attached to the unit.
WARNING: ONLY A QUALIFIED ELECTRICIAN SHOULD
ATTEMPT TO REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.
3