Xerox VersaLink B605 Reference Manual page 21

Power Saver modes are enabled on your device to reduce energy consumption. After the last print, the
device transitions to Ready mode. In this mode, the device can print again immediately. If the device is
not used for a specified period, the device transitions to Low Power mode, then to Sleep mode. In these
modes, to enable reduced-power consumption, only essential functions remain active. The device takes
longer to produce the first print after it exits the Power Saver modes than it takes to print in Ready
mode. This delay is the result of the system waking up and is typical of most imaging devices on the
market.
To save power, you can enable Auto Power Off mode on your device. If Auto Power Off mode is enabled,
you can configure the mode as follows:
Always Allowed: The device powers off automatically after the specified time, and the cumulative
•
Low Power mode and Sleep mode timeouts have elapsed.
• Allowed ONLY When Conditions are Met: The device automatically powers off only after timeouts
have elapsed. The device also powers off if Fax, USB Drive, and Wired and Non-Wired Network have
not been activated.
To change the Power Saver settings, refer to the User Guide at
www.xerox.com/office/VLB605_VLB615docs. For further assistance, contact your System Administrator,
or refer to the System Administrator Guide Web Page Access.
To enable Auto Power Off mode, contact your System Administrator. For details, refer to the System
Administrator Guide at www.xerox.com/office/VLB605_VLB615docs.
To learn more about Xerox participation in sustainability initiatives, go to:
www.xerox.com/about-xerox/environment/enus.html.
Note: Changing the default Power Saver activation times can result in an overall higher energy
consumption of the device. Before you turn off Power Saver modes or set a long activation time,
consider the increase in device power consumption.
Default Power Saver Settings
This device is ENERGY STAR
Equipment. The transition time from Ready mode to Low-Power mode can be set up to 60 minutes. The
default value is 5 minutes. The transition time from Low-Power mode to Sleep mode can be set up to 60
minutes. The default value is set at 1 minute. The total transition time from Ready mode to Sleep mode
can take up to 60 minutes.
To change the Power Saver settings, refer to the User Guide at
www.xerox.com/office/VLB605_VLB615docs. For further assistance, contact your System Administrator,
or refer to the System Administrator Guide.
Xerox VersaLink
®
® -qualified under the ENERGY STAR Program Requirements for Imaging
B605/B615 Multifunction Printer Safety, Regulatory, Recycling, and Disposal
®
Regulatory Information
21
Reference Guide