Using The Remote Control To Operate Your Other Devices; Programming The Remote Control To Operate Your Other Devices; Device Code Setup; Vcr/Pvr - Toshiba 62MX196 User Manual

MX196_EN.book Page 16 Tuesday, June 27, 2006 1:43 PM
Using the remote control to operate
your other devices
Your TV remote control has one dedicated TV mode and five
programmable multi-brand modes: CABLE/SAT, DVD,
VCR/PVR, AUX 1, and AUX 2. The default device modes
and programmable device modes are listed below.
Note: The TV remote control is preprogrammed to operate
most Toshiba devices. To operate a non-Toshiba device or a
Toshiba device that the remote control is not preprogrammed
to operate, you will need to program the remote control. See
"Programming the remote control to operate your other
devices" (at right).
Default device mode control (before
MODE SELECT
programming)
TV

Toshiba TV

CABLE/SAT Toshiba DST 3100 Satellite receiver
DVD Orion DVD
VCR/PVR Toshiba VCR
AUX 1 Yamaha Audio receiver
AUX 2 Onkyo Audio receiver
MODE SELECT Device mode control after programming
TV Toshiba TV
CABLE/SAT
DVD

VCR/PVR

Multi-brand video/audio devices
AUX 1
AUX 2
Note: Although your new TV's remote control includes codes
for many devices, it may not include codes for some or all of
the features on certain devices you wish to control. If you are
unable to program the TV's remote control to operate your
device or some of the features on that device, use the device's
original remote control (or the control buttons on the device).
16
Chapter 2: Using the remote control
Programming the remote control to
operate your other devices

Device code setup

1
Find the code for your device brand in the remote control
device code table on pages 18-21.
If more than one code is listed, try each one separately
until you find one that works.
2
Press the applicable MODE SELECT button (CABLE/
SAT, DVD, VCR/PVR, AUX 1, or AUX 2), until the
MODE SELECT button blinks 3 times.
While holding down E, press the Number buttons to
3
enter the category code (0, 1, 2, 3, 4, or 5, as described
below) plus the four-digit device code for your device.
Category
TVs (Toshiba)
Cable boxes
Satellite receivers
Cable/PVR combos
DBS/PVR combos (1)
DVD players
VCRs
PVRs
DBS/PVR combos (2)
Audio Amps
Audio Amps/Tuners
CD players
If a valid code is entered, the MODE SELECT button
•
will blink twice.
If an invalid code is entered, the MODE SELECT
•
button will blink one long blink.
Point the remote control at the device and press p to test
4
the code.
If the device responds to the remote control, you have
•
entered the correct code.
If the device does not respond to the remote control,
•
repeat steps 3 and 4 using another code.
Note: After programming the remote control, make sure
all necessary keys on the TV remote control (in addition to
p) operate your device. If some keys are not
operational, repeat the device code setup using another
code (if other codes are listed for your device). If, after
trying all listed codes, the necessary keys do not operate
your device, use the device's original remote control.
Category code
0
1
2
3
4
5
MX196 (E/F) Web 213:276