Side Wall Vent Kit - Thermo Pride CLQS1-050T36N Installation And Operation Manual

All installations and services must be performed by qualified service personnel.
If the exhaust vent is to be installed in a location which may be exposed to winds blowing directly
at the vent termination, this alternate configuration should be used. All previous venting
instructions still apply, with the exception that the elbow on the exhaust vent termination is
replaced with a straight tee. A sanitary tee may be used if a straight tee is unavailable, but optimal
performance is achieved with a straight tee. The air intake remains unchanged.
6. Optional Direct Vent Terminations
Three optional vent kits are available for direct vent terminations, refer to Figure 5.
 The concentric vent kits (Thermo Products p/n AOPS7488 & AOPS7489) provide a means
for the vent and intake to be installed through a single opening in the roof or exterior wall. Kit
p/n AOPS7488 is used on furnace models CLQS1-50 & 75. Kit p/n AOPS7489 is used on
furnace models CLQS1-100 &125.
 The sidewall vent cap (Thermo Products part no. 370191) is a cover installed over the exhaust
vent and air intake pipes on the exterior of the building. For horizontal sidewall vent
applications only. This kit may be used on any size furnace in the CLQS1 family.
HORIZONTAL
Figure 5: Optional Direct Vent Kits for the CLQS1 Model Series of Furnaces
AOPS7488 / AOPS7489
CONENTRIC VENT KIT
VERTICAL
21
370191

SIDE WALL VENT KIT