Toshiba 50M2U User Manual Page 5

50m2u user's guide. Uploaded by: CTerrian  
Hide thumbs
Choosing a location for your LED TV
To Display your LED TV on the included Pedestal
Never spill liquids or push objects of any kind into
Observe the following safety precautions:
the TV cabinet slots.
1) Read and follow the pedestal assembly
instructions included with the pedestal.
39) During a lightening storm, do not touch the
CAUTION: Before beginning pedestal assembly,
connecting cables or product.
carefully lay the front of the LCD Panel face down
40) For added protection of your TV from lightning and
on a flat, cushioned surface such as a quilt or
power surges, always unplug the power cord and
blanket. Leave the bottom of the unit protruding
disconnect the antenna from the TV if you leave
over the edge of the surface and assemble the
the TV unattended or unused for long periods of
pedestal as indicated below.
Note: Extreme care should always be used when
41) Always unplug the TV to completely disconnect
attaching the pedestal stand to avoid damage to
from mains power. When the TV is turned off using
the LCD panel.
the on/off switch, it is not completely disconnected
2) Place the TV on a sturdy, level surface that can
from power and a minute amount of current is still
support the weight of the TV.
3) Be sure to secure the TV to a wall, pillar, surface,
42) During normal use, the TV may make occasional
or other immovable structure see item
page 4
snapping or popping sounds. This is normal,
for additional details.
especially when the unit is being turned on or off. If
these sounds become frequent or continuous,
To Display your LED TV using a Wall Bracket:
unplug the power cord and contact a Toshiba
If you decide to wall mount your LED TV, always use a
Authorized Service Provider.
wall bracket Listed by an independent laboratory
(such as UL, CSA, ETL) that is appropriate for the size
and weight of the TV:
1) CAUTION: Two people are required for
Never strike the screen with a sharp or heavy
2) Unplug and remove any cables and/or other
component connectors from the rear of the TV.
44) • The LCD screen of this product can be damaged
3) Remove the screws of the VESA Mounting Pattern
by ultraviolet radiation from the sun. When
show in the table below.
selecting a location for the television, avoid
CAUTION: Do not use the screws removed from
locations where the screen may be exposed to
the back cover to attach the wall mount bracket to
direct sunlight, such as in front of a window.
the TV.
• Never touch, press, or place anything on the
LCD screen. These actions will damage the LCD
4) Always use the screws supplied or recommended
screen. If you need to clean the LCD screen,
by the wall mount manufacturer.
follow the instructions in item 36), on page 4.
5) Follow the instructions provided with your wall
bracket. Before proceeding, make sure the
appropriate bracket(s) are attached to the wall and
the back of the TV as described in the instructions
provided with the wall bracket.
6) After attaching the appropriate bracket(s) to the
wall and the back of the TV, remove the pedestal
stand from the TV, as described below.
Never attempt to service the TV yourself. Opening
7) VESA Mounting Pattern
and removing the covers may expose you to
dangerous voltage or other hazards. Failure to
TV Size
Hole Pattern (HxV)
Screw Size
follow this WARNING may result in death or
serious injury. Refer all servicing not specified in
400mm x 400mm
this manual to a Toshiba Authorized Service
(unit in mm)
46) If you have the TV serviced:
Removing the Pedestal Stand
• Ask the service technician to use only
1) Carefully lay the front of the unit face down on a
replacement parts specified by the
flat, cushioned surface such as a quilt or blanket.
Leave the stand protruding over the edge of the
• Upon completion of service, ask the service
technician to perform routine safety checks to
Note: Extreme care should always be used when
determine that the TV is in safe operating
removing the pedestal stand to avoid damage to
the LCD panel.

   Related Manuals for Toshiba 50M2U

Comments to this Manuals

Symbols: 0
Latest comments:
  • allen Feb 01, 2015 03:45:
    have no remote to reset pin code what can i do
  • joe blow Feb 01, 2015 03:33:
    have no remote to reset the pin code
  • Dina Aug 23, 2014 01:50:
    Why does my tv no longer go in 1080, only 480?