Setting The Sleep Timer; Displaying Tv Status Information - Toshiba 42HL117 Owner's Manual

Setting the sleep timer

You can set the sleep timer to turn off the TV after a set length
of time (maximum of 180 minutes).
To set the sleep timer using the remote control:
Press [ on the remote control to set the length of time until
the TV turns off. Repeatedly press [ to increase the time in
10-minute increments, or press B or b to increase or decrease
the time in 10-minute increments, to a maximum of 180
minutes.
To set the sleep timer using the on-screen menus:
1
Press Y and open the Setup menu.
2
Highlight Sleep Timer and press T.
Setup
Installation
Sleep Timer
PC Settings
Power-On Mode Power-Saving
3
Press the Number buttons to enter the length of time in
10-minute increments.
Sleep Timer
Enter total minutes until the TV
turns off automatically (Maximum
180 minutes)
Cancel
4
Highlight Done and press T.
Note: When a power failure occurs, the sleep timer setting
may be cleared.
To display the remaining sleep time:
Press [.
Sleep Timer
120 minutes
Note: A message will display on-screen when there is one
minute remaining on the sleep timer.
To cancel the sleep timer:
Repeatedly press [ until it is set to 0 minute.
Chapter 6: Using the TV's features
1 2 0
Done

Displaying TV status information

To display TV status information using RECALL:
Press E on the remote control.
The following information will display (if applicable):
Current input (ANT, VIDEO 1, etc.)
•
If ANT is the current input, either "CABLE" (for cable TV)
•
or "ANT" (for over-the-air broadcasts).
Channel number (if in ANT mode)
•
Channel label (if set)
•
Digital signal strength indicator (bar graph in lower right
•
corner of box; for ATSC signal only)
Stereo, Mono or SAP audio status (when HDMI input mode,
•
Dolby Digital or PCM)
Video resolution
•
Aspect ratio of incoming video signal (4:3 or 16:9)
•
V-Chip rating status
•
GameTimer (if set)
•
ANT
1080i
Stereo SAP
123-456
ABCHD
To close the RECALL screen:
Press E again.
To display TV status information using INFO:
Press Q on the remote control.
The following additional information will display for off air
digital channels (if applicable):
Title
•
Duration
•
Detailed description
•
ANT
Stereo SAP
123-456 ,
MLB Young s XXX...
,
ABCHD
Today s Major League Baseball.
Note: The location of the banner can be moved to the top or
bottom of the screen by pressing B or b while the RECALL or
INFO display is on-screen. (The last position will be stored to
memory.)
TV-PG L V
16:9
9:00pm .
1080i 16:9 TV-PG L V
9:00pm - 11:00pm
East
55