Setting The Hdmi ® Audio Mode; Viewing The Digital Signal Meter; Setting The Time Zone - Toshiba 32E200U Owner's Manual

4無
Highlight Done and press
and go back to the Channel Labeling window.
Setting the HDMI
To set the HDMI audio mode:
1無
and open the Sound menu.
Press
2無
Highlight Audio Setup and press
3無
Press p or q to select HDMI 1 Audio and
then press t or u to select the HDMI 1 audio
mode (Auto, Digital, or Analog). (Auto is the
recommended mode.) See "Connecting an HDMI
or DVI device to the HDMI input" ( page 16).
Mode Description
When viewing the HDMI 1 input, if digital
audio from the HDMI input is available,
Auto it will be output. If not, the TV will
automatically detect and output analog
audio from the PC Audio input.
When viewing the HDMI 1 input, digital
Digital
audio from the HDMI input will be output.
When viewing the HDMI 1 input, analog
Analog audio from the PC Audio input will be
output.
4無
To save your settings, highlight Done and press
Note: Because the PC and HDMI-1 inputs
share the same set of analog audio inputs, the
PC Audio menu setting influences the HDMI 1
Audio menu setting. If PC Audio is set to "No,"
the HDMI 1 Audio setting changes to "Auto."
If PC Audio is set to "Yes," the HDMI 1 Audio
Chapter 5: Setting up your TV
to save changes,
audio mode
®
.
setting is set to "Digital" and is grayed out in
the menu. (Also see item 3 on page 12 and
"Setting the PC Audio" on page 44.)

Viewing the digital signal meter

You can view the digital signal meter in the ANT/
CABLE digital TV input source only.
To view the digital signal meter:
1無
and open the Setup menu.
Press
2無
Highlight Installation and press
3無
A new set of Installation menu icons will appear.
Open the Terrestrial menu, highlight Signal
Meter, and press
4無
Press pqtu to select the antenna input and
digital channel whose signal you want to check.
Note:
The physical digital channel number listed in
•
the Signal Meter screen may not correspond
to a virtual TV channel number. Contact your
local broadcasters to obtain the RF channel
numbers for your local digital stations.
The signal strength does not change between
•
virtual channels on the same physical
channel.
To close the screen and return to the
Terrestrial menu:
Highlight Done and press
To return to normal viewing:
Press .

Setting the time zone

The Time Zone setup will allow you to specify the
correct time zone for your region. This feature will
allow the TV status information to show the correct
time zone information ( page 50).
To set the time zone:
1無
From the Setup menu, highlight Installation and
press . A new set of Installation menu icons
will appear.
.
2無
Highlight Time Zone, and press
3無
Press t or u to select the region, highlight Done,
and then press
After the time zone has been set, you will be asked to
set the current Daylight Saving Time status.
.
.
.
.
.
(continued)
27