Advertisement
C Operating your Clean&Charge
• Connect your Clean&Charge with the cord
set to the mains electricity supply.
Open the contact bow (2) by pressing the
release button (3). After shaving, switch the
shaver off and place it upside down into the
Clean&Charge (without having released the
shaver foil).
• Select the operation mode by toggling with
the mode selector (4):
«clean»
«clean» + «charge» (about 75 min)
«charge»
The corresponding lights will come on.
(With cord shavers, only the «clean»
function can be selected.)
• Slide down the contact bow to connect the
shaver and to start the selected pro-
gramme.
If no programme is selected, the default
function «clean» will be started.
• Do not interrupt a running programme,
as it leaves the shaver wet and not fit for
use. If interruption is needed nonetheless,
press the release button.
• After a programme has finished, the corre-
sponding light will go out. Prior to the next
shave, press the release button to release
the shaver.
• When the «cartridge» light starts flashing,
the remaining fluid in the cartridge is
sufficient for about 5 more cleaning cycles.
After these 5 cycles, the cleaning per-
formance will be reduced and the cartridge
has to be replaced.
36
(about 15 min)
(about 60 min)
• When the «cartridge» light illuminates
constantly, the cleaning function is locked
and a new cartridge has to be installed.
Only then, the next cleaning cycle can be
started.
• A cleaning cartridge should be sufficient
for about 30 cleaning cycles. With daily use,
the cleaning cartridge should be replaced
approx. every 4 weeks.
• The hygienic cleaning solution cartridge
contains alcohol which, once opened,
will naturally evaporate slowly into the
surrounding air. Each cartridge, if not used
daily, should be replaced after approx.
8 weeks.
• Do not leave the appliance plugged-in
without the shaver inserted.
• Clean the housing from time to time with a
damp cloth, especially the opening where
the shaver rests.
Advertisement
