Siemens SIMATIC NET CP 5512 Installation Instructions Manual page 51

FCC Compliance Statement
The following statement applies to the products covered in this
manual, unless otherwise specified herein. The statement for
other products will appear in the accompanying documentation.
This equipment has been tested and found to comply with the
limits for a "Class B" digital device, pursuant to Part 15 of the
FCC rules and meets all requirements of the Canadian Interfe-
rence -Causing Equipment Regulations. These limits are desi-
gned to provide reasonable protection against harmful interfe-
rence in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed
and used in strict accordance with the instructions, may cause
harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular in-
stallation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following mea-
sures:
S Reorient or relocate the receiving antenna.
S Increase the separation between equipment and the
receiver.
S Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
S Consult the dealer or an experienced radio/TV technician for
help.
S The manufacturer is not responsible for any radio or televi-
CP 5512 Installation Instructions/Product Information
A5E00175148-02
Technical Specifications
51