Deleting Or Changing A Hard Disk Drive User Only Password In System Setup - Toshiba R200-S2032 User Manual

The System Setup screen appears.
3 Press
screen.
4 Press the spacebar to select User Only password mode.
5 Press the down arrow key to move to the User Password
section.
6 Press the spacebar, then type a password of 1 to 16
characters and press
of letters and numbers in your password.
7 When System Setup prompts you to verify the password,
type it again and press
If the two passwords match, System Setup displays:
Registered
message appears. Repeat steps 6 and 7 to enter the
password again.
8 Press
9 When System Setup prompts you to confirm your
change, Press
Deleting or changing a hard disk drive user only password in
System Setup
To delete or change a user only password in System Setup:
1 Click Start, then click Shutdown, and click OK.
The computer shuts down.
2 Hold down the
button until the on/off light on the system indicator panel
illuminates (blue) for approximately one second. When
the following message appears on the screen: "Check
system, Then press [F1] key," press
The System Setup screen appears.
3 Press
screen.
to move to the HDD PASSWORD section on the
H
. If the two passwords do not match, an error
to save the change.
End
.
Y
key and press and hold the power
Esc
to move to the HDD PASSWORD section on the
H
Toshiba Utilities
Hard disk drive passwords
. You may use any combination
Enter
.
Enter
183
.
F1