Hauling The Machine - Toro ProLine H800 Operator's Manual

Opening the Bypass Valve on the
Hydraulic Pump to Push or Tow
the Machine
1. Locate the control knob for the bypass valve at
the left side of the hydraulic pump
Figure 33
1. Front of the machine
2. Hydraulic pump
2. Using a socket wrench with a 17 mm socket,
rotate the control knob 3 turns counterclockwise
(Figure 33).
Important:
Do not rotate the control knob
more that 3 turns.
(Figure 33).
g231794
g215176
3. Control knob (bypass
valve)
Closing the Bypass Valve on the
Hydraulic Pump to Operate the
Machine
1. Locate the control knob for the bypass valve at
the left side of the hydraulic pump
2. Using a socket wrench with a 17 mm socket,
rotate the control knob
until you feel resistance (the bypass valve is
closed).

Hauling the Machine

•
Use care when loading or unloading the machine
into a trailer or a truck.
•
Use full-width ramps for loading the machine into
a trailer or a truck.
•
Before tying down machine, lower the deck
completely.
•
Bind the machine securely to the transport vehicle
using straps, chains, cable, or ropes. Align both
front and rear straps down and outward from the
machine.
Binding the Front of the Machine
Loop tie-downs around the corners of the carrier frame
or use the anchor hoops where provided.
and Figure 35).
Machines with 1 anchor hoop on the carrier frame
1. Front tie-down locations
36
(Figure
(Figure 33) clockwise
(Figure 34
Figure 34
33).
g231805