IBM Storwize V7000 Installation Manual page 32

Figure 8. Unlocking the cable retention bracket
3. Slide the cable retention bracket away from the power supply unit until there is
4. Attach a power cord to each of the two power supply units in each enclosure.
5. Place the cable retention bracket around the end of the cable that plugs into the
6. Slide the cable retention bracket along the cord until it fits snugly against the
14
IBM Storwize V7000: Expansion Enclosure Installation Guide
enough room to attach the cable retention bracket to the cable. When sliding
the bracket away from the cable plug-in, pull the lever on the bracket that
controls the cable tie slightly towards the center of the canister. You do not
need to pull the lever to slide the bracket towards the cable plug-in.
Ensure that cables are installed in an orderly way to reduce the risk of cable
damage when replaceable units are removed or inserted.
power supply unit.
plug end of the cable, as shown in Figure 9 on page 15.