Closing The Display Panel - Toshiba P105-S9337 User Manual

79
Getting Started
Turning off the computer
The computer saves the status of all open programs and files,
turns off the display, and enters into a low-power mode. The
on/off light blinks amber indicating the computer is in
Standby mode.
Configuring Standby mode options
You can place the computer into Standby mode by either
pressing the power button or closing the display panel. You
can also specify an amount of time after which the computer
automatically goes into Standby mode.
To use any of these methods, you first need to enable them in
the Power Options Properties window. For information on
configuring the power options, see "Power Schemes" on
page 112.
Once the computer is configured, you can place it into
Standby mode by either pressing the power button or closing
the display panel, depending on the Standby options set.
Starting again from Standby mode
To start up the computer from Standby mode, press the power
button until the on/off light glows blue. The computer returns
to the screen(s) you were using.
If you place the computer in Standby mode by closing the
display panel, you can start it again by opening the display
panel.

Closing the display panel

After you have turned off the computer, close the display
panel to keep dust and dirt out of the computer.