Toshiba P105-S9337 User Manual page 65

The other three virtual buttons have no default settings. You
must configure these buttons in the Mouse Properties dialog
box before they can be used.
In order to use the virtual buttons you must first enable Dual
Mode in the Mouse Properties dialog box. After that, you can
use the virtual buttons as follows:
1 Tap the mode switch button to enable the virtual buttons.
2 Tap the virtual button assigned to the application you
wish to launch, or slide your finger on the volume control
bar to adjust the volume to the desired level.
3 When the operation is complete, the Dual Mode Pad
automatically disables the virtual buttons.
The virtual buttons cannot be used until the mode switch
button is tapped again.
The virtual buttons and Dual Mode can be enabled or
changed in the Mouse Properties dialog box.
Enabling Dual Mode
To enable Dual Mode:
1 Click Start, and then Control Panel.
The Control Panel window appears.
2 Click Mouse.
The Mouse Properties window appears.
3 Click the Device Settings tab, and then Settings.
The Properties for Synaptics LuxPad window appears.
4 In the left side of the window, select Tapping.
Getting Started
Using the Dual Mode Pad
65