Bosch TPA 300 User Manual page 18

The available
sensors are
displayed, select the
one you are using.
2.1. C S
REATE ENSOR
This section is to create a Make / Model / Year specific sensor if the "old" sensor can't be
cloned. The new sensor ID(s) are generated by the tool, and may not be the same as the
original one. A TPMS reset is required when replacing new sensors. See section 2.
Scroll Right and left
to select the
CREATE option.
Position the sensor
in front of the tool
antenna to send ID
to the blank sensor.
Wait a few seconds
during the
programming
process.
UM-BTPA1-6 16/54
TPA 300 user guide
= Continue
= Previous
= Continue
= Previous
= Program
= Previous
User guide BOSCH TPA 300