Toro Outcross 9060 Series Operator's Manual page 49

Types of diesel particulate filter regeneration that require you to park the machine:
Type of Regeneration
Parked
Recovery
Using the DPF Regeneration Menus
Accessing the DPF Regeneration Menus
1. Select the service menu icon in any mode and scroll to the R
2. Select the regeneration function you need.
Time Since Last Regeneration
1. Access the DPF Regeneration menu, and scroll to the L
2. Select the L
AST
3. Use the L R
AST EGEN
parked, or recovery regeneration.
4. Select the previous screen icon to return to the DPF regeneration screen.
Setting the Inhibit Regen
Reset Regeneration Only
A reset regeneration produces elevated engine exhaust. If you are operating the machine around trees, brush,
tall grass, or other temperature-sensitive plants or materials, you can use the I
the engine computer from performing a reset regeneration.
Note:
The I R
NHIBIT EGEN
an enclosed area.
Note:
If you set the InfoCenter to inhibit regeneration, the InfoCenter displays an advisory every 15 minutes
while the engine requests a reset regeneration.
Important:
When you shut off the engine and start it again, the inhibit regen setting defaults to O
1. Access the DPF Regeneration menu, and scroll down to the I
Conditions that cause DPF regeneration
Occurs because the computer determines that the
automatic DPF cleaning has not been sufficient.
Also occurs because you initiate a parked
regeneration
May occur because the inhibit regen has been
initiated and has disabled the automatic DPF
cleaning from occuring
May result from using the incorrect fuel or engine
oil
Occurs because the request for parked recovery
has been ignored, allowing the DPF to be critically
plugged
R entry.
EGEN
field to determine how many hours you have run the engine since the last reset,
option is always used when maintenance is being performed on the machine in
DPF description of operation
• When the reset-standby/parked or recovery
regeneration icon
requested.
• Perform the parked regeneration as soon as
possible to avoid needing a recovery regeneration.
• A parked regeneration requires 30 to 60 minutes
to complete.
• You must have at least a 1/2 tank of fuel in the
tank.
• You must park the machine to perform a parked
regeneration.
• When the reset-standby/parked or recovery
regeneration icon
is requested.
• A recovery regeneration requires up to 3 hours
to complete.
• You must have at least a 1/2 tank of fuel in the
machine.
• You must park the machine to perform a recovery
regeneration.
EGENERATION
R option.
AST EGEN
R
NHIBIT EGEN
49
or a regeneration is
a recovery regeneration
option.
R setting to prevent
NHIBIT EGEN
option.
.
FF