Preparation; Attaching The Stand Unit - Sharp AQUOS LC-46LE831E Operation Manual

Preparation

Attaching the stand unit

• Before performing work, spread cushioning over the
surface on which you will be laying the TV. This will
prevent it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect
installation of the stand may result in the TV falling
over.
Confirm that there are screws with the stand
1
unit.
1 For 46 inch models
(four long screws, four middle screws and one
short screw)
2 For 40 inch models
(three long screws, three middle screws and
one short screw)
Attach the supporting post for the stand unit
2
onto the base using the long screws with a
screwdriver as shown.
Supporting
post
 
46 inch models 40 inch models
Insert the stand into the openings on the bottom
3
of the TV (hold the stand so it will not drop from
the edge of the base area).
Soft cushion
 
46 inch models 40 inch models
Insert and tighten middle screws into the holes
4
on the rear of the TV.
 
46 inch models 40 inch models
5
Attaching the stand cover.
5
Insert the stand cover.
1
Insert and tighten a short screw into the hole
2
of the stand cover.
NOTE
• To detach the stand unit, perform the steps in reverse
order.
• A screwdriver is not supplied with this product.
• The TV can be rotated up to 20 degrees to the right and
left.