Updating Your Tv Via Dvb-T/T2; Getting Update Information - Sharp AQUOS LC-60LE636E Operation Manual

Appendix

Updating your TV via DVB-T/T2*

Ensure that your TV software version is always up to
date. From time to time SHARP will make updated
TV base software and DVB software available.
* 636 series only
View setting
Download setup
Go to "Menu" > "Setup" > "View setting" >
"Individual setting" > "Standby search" >
"Download setup".
Searching for updates*
* All countries except UK, Sweden and Italy are set to
"No" for this function.
The TV automatically determines whether a new
software version is available when the TV is in
standby mode.
Item
Automatically searches for new
software updates available when the
Yes
TV is in standby mode.
Does not search for update
No
information.
Checks if there is new software
Now
immediately.
Downloading the software
You can select the method of update.
If the software is updated, the confirmation
1
message "New download information has been
detected." appears.
• If the TV receives the update service while in
standby mode, a confirmation message displays
after turning on the power.
Follow the screen prompts.
2
Item
Starts downloading immediately.
It takes approximately one hour to
update. You cannot carry out other
operations while downloading.
Yes
• Cancels the download by pressing
; on the remote control unit when
"Discontinue" is displayed on the
screen during the update.
Starts downloading automatically
several minutes after entering standby
No
mode.
NOTE
• Updating the software may take some time.
65

Getting update information

Information
Message list
When new software is detected, you can confirm the
update information and download the software from
"Message list".
Go to "Menu" > "Setup" > "Information" >
"Message list".
NOTE
• When the TV succeeds at downloading new software,
the message is updated in the "Message list" of the
"Information" menu.
• The software update will not be carried out if there is no
new software available at the specified download time.
Information
Receiver report
Display reports regarding failures and changes for
timer settings.
Go to "Menu" > "Setup" > "Information" >
"Receiver report".
Information
Identification
You can check the TV ID on the screen for reporting
to customer service.
Go to "Menu" > "Setup" > "Information" >
"Identification".