Delete Channel; Programmed Scanning - Alinco DJ-CRX7 Instruction Manual

BASIC OPERATIONS
2. Press /
3. Press key, the top corner of LCD displays "
and channel is stored successfully. Repeat the same to overwrite the channel with different data, but
overwrite protection is not available.

Delete Channel

To delete a stored channel follow the below steps.
1. Under standby state, press
into channel mode, channel number flashes.
2. Press /
3. Press key, the top corner of LCD displays "
and clear up frequency information of current channel, deletion is successful.

Programmed Scanning

This is a type of VFO scan, and scans only the designated frequency range set into the L1/U1 and L2/U2
channel pairs in the memory mode. This feature is referred to as also "Search" and 2 pairs available. Both
channel pairs can be set freely in the VHF and UHF bands, but the pair channels must be within the same
band. Follow the memory edit instruction to store the lower and upper frequency settings in the L(lower)
and U(upper) pair channels. To scan, in the VFO mode, select a frequency within the scanning range.
Press " " key. LCD displays "
When starts scanning from the off-range frequency, it scans whole receiving range like a normal VFO scan.
15
to select desired editing channel number.
key, the top corner of LCD displays "
to select desired deleting channel number.
" icon on the upper right corner. Press "
" icon, press and hold
" icon, press
" icon, press and hold
key until a beep sounds,
key to switch
key until a beep sounds,
" key to start scanning.