Advertisement
Finished Wall
400
INSTALLATION
TO REMOVE EXISTING TOILET
Turn off the water supply. Flush the toilet, and use a sponge
to remove the remaining water from the tank and bowl.
Disconnect the supply shut-off valve (if present), and remove
the old tank and bowl.
Remove the old gasket from the floor
and the closet flange with a putty knife.
Remove the old T-bolts and discard
them.
NOTICE:
if the new toilet is not
installed immediately, temporarily stuff
a rag into the closet flange.
NOTICE: Do not use white cement or high lime content
cements to install this toilet. The expansion of cement due to
a rise in temperature may make the toilet crack or cause
damage. Kohler is not responsible for any damage caused by
installation with the use of cement.
TO INSTALL SUPPLY
SHUT-OFF VALVE
Install the supply shut-off valve so it is
160mm above the finished floor line,
and 200mm to the left of the closet
flange centerline.
The centerline of the supply shut-off
valve outlet should extend 67mm from
the finished wall. Install the supply
shut-off valve with the outlet vertical.
1267611-T01-B
717
C
L
OF OUTLET
Kohler reserves the right to change marked dimensions without prior notice.
160
305/400
K-5504T-TFC
685
Supply
387
200
Fig.#2
Closet Flange
2
Supply Shut-Off Valve
200
Closet Flange
Centerline
Fig.#3
3
-3-
489
(
)
160mm
200
mm
FRONT OF BOWL
655
373
265
T
67mm;
Advertisement
