Getting Started - VTech nickelodeon PAW PATROL Mighty Pups Touch & Teach Word Book Parents' Manual

GETTING STARTED

Battery Removal and Installation
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the unit, use a screwdriver
to loosen the screw and open the
battery box.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 2 new AA (LR6/AM-3)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended for maximum performance).
5. Replace the battery cover and tighten the screw to secure.
Note:
If there is no response when the unit is switched on, please
insert new batteries and try switching it on again.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging
(if removable).
• Rechargeable batteries are only to be charged under adult
supervision.
4