Ink Pack Safety Instructions - Epson WorkForce Pro WF-C579R User Manual

• Unplug the product and refer servicing to qualified service personnel under the following conditions: if
the power cord or plug is damaged; if liquid has entered the product; if the product has been dropped
or the case damaged; if the product does not operate normally or exhibits a distinct change in
performance. Adjust only those controls that are covered by the operating instructions.
• Leave the ink packs installed. Removing the ink packs can dehydrate the print head and may prevent
the product from printing.
• Before transporting the product, make sure that the print head is in the home (far right) position.
• When storing or transporting the product, do not tilt it, stand it on its side, or turn it upside down;
otherwise, ink may leak.
• Do not attempt to move the product by yourself.
Parent topic:

Ink Pack Safety Instructions

• Keep ink packs and maintenance boxes out of the reach of children and do not drink the ink.
• Be careful when you handle used ink packs; there may be ink remaining around the ink supply port. If
ink gets on your skin, wash it off with soap and water. If it gets in your eyes, flush them immediately
with water. If discomfort or vision problems continue after a thorough flushing, see a doctor
immediately. If ink gets in your mouth, see a doctor right away.
• Do not put your hand inside the product or touch the ink packs during printing.
• Install a new ink pack immediately after removing an expended one. Leaving ink packs uninstalled can
dry out the print head and may prevent the product from printing.
• Do not remove or tear the label on the ink pack; this can cause leakage.
• Do not remove the transparent seal from the ink supply area. This may cause the ink pack to become
unusable.
• Do not touch the green IC chip on the side of the handle. This may prevent normal operation.
• Do not shake ink packs too vigorously; otherwise ink may leak.
• Use an ink pack before the date printed on its package.
• Do not disassemble an ink pack or a maintenance box. Ink may get in your eyes or on your skin.
• Store ink packs in a cool, dark place.
• After bringing an ink pack inside from a cold storage site, allow it to warm up at room temperature for
at least 12 hours before using it.
• Store ink packs with the bottom facing down.
Important Safety Instructions
427