Outside Back Exhaust; Adapting Microwave Blower For Outside Back Exhaust - Samsung SMH1711S Installation Instructions Manual

C.

OUTSIDE BACK EXHAUST

C1.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE BACK
EXHAUST
1.
Remove and save screw that holds blower Plate
to microwave.
Screw
Blower Motor
3.
Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
BEFORE: Fan Blade
Openings Facing Forward
End A
CAUTION: Do not touch blade of blower to prevent
cracking and breaking. Hold outer case when the
blower is removed and re-installed.
4.
Rotate blower unit counterclockwise 180°.
Before Rotation
Back of
Microwave
Installation Instructions
2.
Lift up the Blower Plate.
Back of
Microwave
Blower Plate Screw
After Rotation
Back of
Microwave
(HORIZONTAL DUCT)
5.
Place the blower unit back into the opening.
AFTER: Fan Blade
Openings Facing Back
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
NOTE: The blower unit exhaust openings should
match exhaust openings on rear of microwave
oven.
6.
Close the blower plate and attach the exhaust
adaptor to the rear of the oven by sliding it into the
guides at the top center of the back of the oven.
End B Push in securely until it is in the lower locking
Guide
tabs. Take care to assure that the damper hinge is
installed so that it is at the top and that the
damper swings freely.
14
End B
Adaptor
From Blower motor screw
(after attached the exhaust adaptor)
End A
Back of
Microwave
Guide
blower plate screw